Tilesafe
Membrane system has been developed to provide
waterproofing beneath ceramic tiles in bath/shower
rooms and other wet room areas.
Durability
Subject to normal conditions of use, Tilesafe
will provide an effective barrier to the
transmission of liquid water vapour for
the life of the tiles applied onto it.
Specification
M40 - Stone/Concrete/Quarry/Ceramic Tiling/Mosaic,
in accordance with NBS Clause 470.
Ancillary
Products
There is a range of ancillary products for
use with Tilesafe
which include:
- Tilesafe
Primer - an acrylic emulsion primer for
coating all surfaces prior to the application
of Tilesafe Reinforcing Tape and Tilesafe
Membrane.
- Tilesafe
Reinforcing Tape - a tape for reinforcing
all wall junctions, butt joints and other
detail work in the membrane.
- Tilesafe
Jointing Compound - a high quality, gun
applied, butyl rubber-based sealant for
use at all butt joints in the membrane,
pipe entries, wall to wall and wall to
floor interfaces.
- Tilesafe
Putty - a non-setting, self supporting
mastic for filling small gaps or voids
around tile entries, etc. prior to application.
Safety
Tilesafe Jointing
Compound is flammable and should be used
in well-ventilated areas away from sources
of ignition. The product can affect sensitive
skins. Gloves or barrier cream should always
be used by operatives and hands thoroughly
washed at the end of each working period.
Do not allow the product to enter watercourses.
Full health and safety instructions are
contained on the material safety data sheets,
and these must be referred to before use.
Supply
Availability - Tilesafe
is available from CCL
Specialist Supplies. Packaging is as detailed
below. Contact us for ordering information.
Storage
Tilesafe Membrane,
and its ancillary products, should be stored
in original cartons. The products should
be kept upright, protected from frost, and
out of direct sunlight. i.e. below 35 °C.
Cartons should not be over-stacked.
Care should be taken to
ensure the temperature is at least 10 °C.
Conditioning of the membrane in a warm area,
prior to use, will enhance its adhesion
properties during application.
Technical
Services
The CCL Technical Department is available
to advise on individual projects and to
prepare or assist in the preparation of
specifications and drawings.
The above performance figures are typical
values and should not be considered a product
specification.
Top
